country=CN

ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev

update_config=1

network={

    ssid="AMRHU"

    psk="12345678"

    key_mgmt=WPA-PSK

    priority=1

}

# For more options and information see

# http://rpf.io/configtxt

# Some settings may impact device functionality. See link above for details

# uncomment if you get no picture on HDMI for a default "safe" mode

#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible

# and your display can output without overscan

disable_overscan=1#可以去掉开机屏幕周围的黑色边框

# uncomment the following to adjust overscan. Use positive numbers if console

# goes off screen, and negative if there is too much border

#overscan_left=16

#overscan_right=16

#overscan_top=16

#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus

# overscan.

#framebuffer_width=1280

#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output

hdmi_force_hotplug=1#

# uncomment to force a specific HDMI mode (this will force VGA)

hdmi_group=2#DMT模式

hdmi_mode=58 #分辨率为适应屏幕分辨率的选择

# uncomment to force a HDMI mode rather than DVI. This can make audio work in

# DMT (computer monitor) modes

hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or

# no display

config_hdmi_boost=4

# uncomment for composite PAL

#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.

#arm_freq=800

# Uncomment some or all of these to enable the optional hardware interfaces

#dtparam=i2c_arm=on

#dtparam=i2s=on

#dtparam=spi=on

# Uncomment this to enable the lirc-rpi module

#dtoverlay=lirc-rpi

# Additional overlays and parameters are documented /boot/overlays/README

# Enable audio (loads snd_bcm2835)

dtparam=audio=on

sudo passwd pi

sudo apt-get install xrdp

sudo apt-get purge tightvnc xrdp

sudo apt-get install tightvncserver xrdp

sudo /etc/init.d/xrdp restart

sudo apt-get update

sudo apt install curl libunwind8 gettext

curl -sSL -o dotnet.tar.gz https://download.microsoft.com/download/1/f/7/1f7755c5-934d-4638-b89f-1f4ffa5afe89/dotnet-runtime-2.1.2-linux-arm.tar.gz

sudo mkdir -p /opt/dotnet && sudo tar zxf dotnet.tar.gz -C /opt/dotnet

sudo ln -s /opt/dotnet/dotnet /usr/local/bin

dotnet publish -r linux-arm

cd ./Documents/HslCommunicationCoreDemo

chmod 777 ./HslCommunicationCoreDemo

./HslCommunicationCoreDemo

chmod 777 /home/pi/Documents/HslCommunicationCoreDemo/HslCommunicationCoreDemo

/home/pi/Documents/HslCommunicationCoreDemo/HslCommunicationCoreDemo　

./testboot.sh

sudo nano /etc/rc.local

exec /home/pi/testboot.sh

su pi -c "exec /home/pi/testboot.sh"

sudo systemctl status rc-local